What tools do I need to install the floor spring?
Everyone should have seen springs when they were young, and springs appear more frequently in daily life, because he is not only a material used when installing objects, but also a playmate of many people when they were young. Of course, the situation is different now. , The quality of the current spring has improved a lot, and the type is also much more than before, so what tool is used to install the ground spring?
An angle grinder, hammer, chisel, electric hammer, spring body and cement are needed. First, take out the main body of the floor spring and place it at the predetermined installation position. At this time, take a plumb line from the floor spring to push the shaft Place a vertical line at the center of the circle.
1. Move the position of the floor spring so that the center of the plumb body is exactly placed at the mark position of the flat shaft of the floor spring. At the same time, pay attention to the level of the floor spring and the verticality of the front, back, left, and right directions, and then trace the outline of the floor spring body.
2. Implement slotting:
Use an angle grinder to cut out a notch with a depth of about 3-5mm from the edge of the contour area of the floor spring that has been drawn, and then use an electric hammer or hand chisel to excavate the ground material in the contour area of the floor spring, which can be matched with an angle grinder Machines, electric hammers, and chisels are used repeatedly, chisels are used for details, electric hammers for larger materials, and angle grinders can be used for side lines. At the same time, the depth of the floor spring groove can be measured, and the floor spring body can be placed when it is close to the thickness. The trough, see if it can be kept below the ground.
3. Steady floor spring body:
When the floor spring body can be completely put into the ground trough, the step of stabilizing the floor spring body can be carried out, but cement can also be used, but the cement setting time is longer. Take out the floor spring body, add an appropriate amount of quick-drying powder to the floor trough, add water and stir until the consistency is appropriate, then put it in the floor spring body, use a rubber hammer or a wooden block and then knock the floor spring with an iron hammer to make the floor spring You can restore the level of the surface to the surrounding ground, then use the plumb line to find the position of the axis of the ground spring, and fine-tune the body of the ground spring

