Many buildings now use glass floor spring doors, and the reason why glass floor spring doors can be opened and closed is because there is a floor spring at the bottom, which can be used to control the rotation of the door. Through adjustment, you can also control the speed and control the height of the glass door. What should I do if the floor spring door sags during adjustment? What aspects should I pay attention to when adjusting?
1. How to raise the floor spring door drooping
1. First, you need to open a cover on the floor spring, and then you can see the screws on it, distributed in four corners.
2. The height can be adjusted up and down by adjusting the screw. You can rotate the screw. If you want to adjust the height, just loosen it.
3. If the two doors are not neat, you can tighten the third screw, and then loosen the fifth screw. While adjusting the height, check whether the height is suitable or not. If it is adjusted to a more suitable height, fix it.
2. What aspects should be paid attention to when adjusting
1. There is a shaft on the floor spring door, this is the supporting point, it must be firmed up when installing.
2. If you want to adjust the height, keep the upper shaft and the lower door shaft at the same vertical angle, so as to prevent the door from being up and down.
3. After adjustment, use screws to fix the connection and prevent it from falling off to prevent potential safety hazards. If you find that the upper and lower axis is not vertical, you need to adjust it immediately.
4. When adjusting, you need to prepare a complete set of tools, such as a wrench, a screwdriver, a screwdriver, and so on.