1. First of all, it is necessary to slot the ground, put the spring to the corresponding main, and draw the main outline of the ground spring so that the rotating shaft of the spring can coincide with the rotating shaft of the door clamp.
2. Using an angle grinder, cut a slot of about 5 mm at the edge of the floor spring. This hole needs to be consistent with the requirements on the manual to avoid loosening at a later stage.
3. Fix the ground spring in the correct position of the ground slot, and then let the hinge of the ground spring be able to be replaced with the shaft hole of the door leaf.
4. There are three directions of screws on the floor spring, which need to be adjusted so that the rotating shafts can be overlapped to ensure the verticality of the door leaf.
5. After adjusting the closing speed of the glass door, the cover can be installed, thus completing the installation of the floor spring glass door.
Purchase advice
1. Select the ground spring with suitable bearing capacity. If the bearing capacity is too large, the overall cost of the purchase will be increased, and the door opening effect should not be achieved if it is too heavy. If the load is too light, it will easily affect the service life of the floor spring.
2. In the selection of the European ground spring, it is necessary to consider the climatic factors. In the cold area, the anti-freeze hydraulic oil spring should be selected to avoid the temperature being too low to make the ground spring unable to operate normally.
3. If it is an outdoor door leaf, it should use a double-cylinder floor spring. For the external wind factor, the double-cylinder floor spring has an advantage over the single-cylinder ground spring.