The floor spring is a small device of the door. Its function is to make the door easier to open and retain elasticity. If the local spring is broken, it needs to be replaced, but how to replace the floor spring?
The floor spring is a small device of the door. Its function is to make the door easier to open and retain elasticity. If the local spring is broken, it needs to be replaced, but how to replace the floor spring?
1. First, remove the sandwich panel on the glass door with screws, and then lift the glass door. Use screws to remove the four screws of the floor spring, and then take out the floor spring. Then record the deviation value of the floor spring of the glass door, and mark the cross line of the standard position where a new floor spring needs to be replaced.
2. Then gouge out the damaged floor spring and surrounding pits, clean up the remaining ash and wipe it with a damp cloth immediately. Then use a brush and banana water to brush around the pit, make it wet, and then brush the plain cement slurry or interface agent.
3. Put the new floor spring in place according to the marked cross line position, and fix it with small wooden wedges around it. The high and low position pads use different specifications of steel bar heads for the bottom.
4. Mix the 1:15 cement according to the required amount, and the coarse sand "dry hard cement mortar". The dryness and hardness shall be subject to the dampness of the hand kneading. If it is too wet, it will not act as an instant fixation of the floor spring. Fill the pits in layers, and use a hammer and steel chisel to tap them as they are filled. During the entire operation, the position of the floor spring should be checked at different levels. If there is any displacement, adjust it at any time.
5. When it is filled to be level with the ground, hammer it with a hammer and then use an iron trowel to smooth it with a little water to survive. If there is a floor tile surface layer, just pour a thin layer of cement slurry on the rough surface layer to affix the floor tile surface layer.
6. Before completion, after checking the front and back, left and right, height deviation, etc., there is no error, and then cover a layer of plastic cloth to keep moisture from losing.
7. To install a new floor spring, the same method as the installation method. If you can't do it by yourself, ask someone to help yourself

